[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] Cable connectors
I seem to recall that 'back in the day', Gordon Nelson was
concerned about keeping the feedlines from his loops as
short as practical for the application. Realizing that his
recommended feedline was car radio cable with the original
center conductor removed and replaced by insulated #22 or
so ( with the braid soldered together on each line about
every foot ) I wonder if it is in fact possible to get
what you're aiming for.
What might have worked better is to remove the single center conductor and
replace it with a twisted pair of #24 or so wires. Then modify the loop
output and receiver input for a balanced connection. Would have eliminated
any ground loop issues.
Craig Healy
Providence, RI
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx