Re: [IRCA] [am] Remote SDR operation

["Craig Healy" <bubba@xxxxxxxxxxxxxxxxxxxx>]

I had looked at that, but it's a somewhat dated design.  Things move very
rapidly these days.  If someone who has used it remotely has good words to
say about that, then it's a consideration.  Do the docs say what's needed
for remote use?  Does the remote use also pipe the audio back?  Ideally it
would work the same by remote as locally.

Meanwhile, I should send a note to both RFSpace and Moetronics requesting an
ethernet port.  One that can work either on a local network or by the
internet.  I would think that would increase the potential user base by a
fair amount, so economically it would make sense.

Craig Healy
Providence, RI

----- Original Message ----- 
From: "John H. Bryant" <bjohnorcas@xxxxxxxxxxxxxx>
To: "Mailing list for the International Radio Club of America"
<irca@xxxxxxxxxxxxxxxx>
Sent: Monday, April 14, 2008 10:28 AM
Subject: Re: [IRCA] [am] Remote SDR operation


> Craig,
>
> If you were serious about that last statement, you might want to go
> out and buy a WinRadio 313e. Before you die laughing, Chuck Rippel
> (of R-390A restoration fame) and I are quietly in love with these
> wonderful SDRs.... if you believe in active, real time DXing... they
> are nimble moving around the band, have a first rate GUI and hear
> things very well.  Their internal audio recorder is a good one,
> too.  Their RF recording capability (20 kHz wide) is pathetic and
> I've never really used it.
>
> WinRadio sells a complete add-on for remotely operating the 313e and
> (I understand) it has been used very successfully by various
> governmental agencies. I don't personally know of anyone who has used
> this receiver remotely. So "If I found an SDR that would be operable
> over the internet, I'd buy it
> today." maybe you want to check it out?
>
> If you do, Craig, please keep us informed!
>
>
> John Bryant
>
>
> Stillwater, Oklahoma, USA
> Rcvrs: WiNRADiO 313e, Eton e1, NRD-535(kiwa-mods)
> Antennas: 700' NE/SW mini-Bev, Wellbrook Phased Array (pre-production
version)
>
>
>
>
> At 08:12 AM 4/14/2008 -0400, you wrote:
> > > > Those of you who have experience with the DX Tuners software may
> > > > know if it can interface with the current crop of SDRs...
> > >
> > > I've had radios on both DX Tuners and it's successor, GlobalTuners.
> > > Most of the radios on the network right now are Icom PCR100/1000/1500
> > > models, although they've also supported other models like my Icom R-75
> > > and 718 ham transceiver. Don't know if the new person running the
> > > system would be interested in supporting the RFSpace models but you
> > > could send him an email: Ivo@xxxxxxxxxxxxxxxx
> >
> >That would be interesting.  If Spectravue would take the bugs out of the
> >current program and allow remote operation, that would be good.  Ideally
> >RFSpace would add an ethernet port and the Spectravue would accomodate
this,
> >it would be ideal.  I hope it's a matter of (short) time before this
> >appears.
> >
> >In many ways this would be a significant step up.  Using ethernet would
> >eliminate the current USB port speed limitation and perhaps allow greater
> >recorded or viewed bandwidth concurrent with demodulation.
> >
> >If I found an SDR that would be operable over the internet, I'd buy it
> >today.
> >
> >Craig Healy
> >Providence, RI
> >
> >
> >_______________________________________________
> >IRCA mailing list
> >IRCA@xxxxxxxxxxxxxxxx
> >http://montreal.kotalampi.com/mailman/listinfo/irca
> >
> >Opinions expressed in messages on this mailing list are those of the
> >original contributors and do not necessarily reflect the opinion of
> >the IRCA, its editors, publishing staff, or officers
> >
> >For more information: http://www.ircaonline.org
> >
> >To Post a message: irca@xxxxxxxxxxxxxxxx
>
>
>
>
>
>
>
>
>
>
>
>
> _______________________________________________
> IRCA mailing list
> IRCA@xxxxxxxxxxxxxxxx
> http://montreal.kotalampi.com/mailman/listinfo/irca
>
> Opinions expressed in messages on this mailing list are those of the
original contributors and do not necessarily reflect the opinion of the
IRCA, its editors, publishing staff, or officers
>
> For more information: http://www.ircaonline.org
>
> To Post a message: irca@xxxxxxxxxxxxxxxx
>
>
>


_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx