Re: [IRCA] 738 & SAH's from Michigan - Friday morning 9/7/2012
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [IRCA] 738 & SAH's from Michigan - Friday morning 9/7/2012



Great information presented here, thanks Bob.  And thanks to everyone
else who replied and provided sample audio clips, it's much appreciated!

-Tim

On Fri, 2012-09-07 at 13:57 -0400, rfoxwor1@xxxxxxxxxxxxxxx wrote:
> Russ wrote,
> 
> > An audible heterodyne was often not present with differences of a few kHz, thus 'subaudible'. 
> 
> I think you meant to say a difference of a few _Hertz_
> 
> >Visually, you could 'see' the offset, and sometimes the beat between the two signals which might or more likely not be audible. So you saw the SAH on the scope. You used the same equipment to determine the actual offset value.
> > 
> > You could also manually count the beats - audibly or visually, as applicable - to determine the offset.
> > 
> > Russ Edmunds
> 
> 
> Another important factor is that the input to the vertical amplifier in the
> scope is taken from the AGC buss of the receiver, and not from the audio
> section. This is for the same reason, the audio response of the receiver
> at frequencies of 15 Hz or less is poor, just as your hearing is poor at such
> low frequencies. It is _recommended_ to use a DC-coupled oscilloscope. The
> original published work on SAH's was done (ca. 1965) by Gordon Nelson using Dumont
> 304 scopes with DC vert coupling and with scopes using P7 phosphor, so the
> horizontal sweep rate could be reduced to maybe 1 or 2 sweeps/second, if needed.
> This technique worked best when there were just 2 signals present, so that
> the difference would be clearly seen as a single "beat" wave. Also the AGC time
> constant could be modified for better LF response. Fourier analysis could be
> used to identify multiple sine waves present.
> 
> If you were looking at two signals, a few Hz apart, and at similar strengths,
> you could hear a "whoosh-whoosh-whoosh" as the two signals beat together.
> Nelson had discovered that two signals, a few Hz apart, *and differing by
> maybe => 30 dB*, could both be detected by looking for the very small displacement
> in the AGC voltage, when it was too small to be detected audibly. Since Nelson
> spent time looking for secondary European signals fading in underneath
> much stronger big signals, this was useful to him. He used published data
> from the EBU monitoring stations that listed European carrier freq's to 1 Hz
> resolution as a guide to identifying signals too weak to produce audio. Note,
> too that freq tolerances back then were much looser than today.
> 
> The existance of a weak "beat" was a precursor indicator of the possibility
> of hearing audio as the signal hopefully faded up to readability. Getting an
> audible signal was always the goal. This was a guide to where to spend your
> DXing effort, as a SAH display of an audible SAH beat is sort of superfluous info.
> 
> There is no reason this technique couldn't be done today, except for strong
> artifacts from sideband splash from signals 2 to 5 kHz away, masking
> the weak SAH trace, being so much worse today than we had in the 1960's.
> 
> Bob Foxworth k2euh


_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx