[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] RF Conversion
- Subject: Re: [IRCA] RF Conversion
- From: "Mark Durenberger Mobile" <Mark4@xxxxxxxxxxxxxxx>
- Date: Sat, 16 Feb 2013 17:04:59 -0500
When we built Target Field we found one that started at around 300 khz but I
don't recall who made it...I just know it was around $20K!
Mark Durenberger
On the Road
-----Original Message-----
From: Craig Healy
Sent: Saturday, February 16, 2013 3:47 PM
To: Mailing list for the International Radio Club of America
Subject: Re: [IRCA] RF Conversion
I am beginning to see if there are any adequate RF to fiber optic
conversions, and conversion back to the same RF. My goal is to use fiber
optic cable rather than coax or twisted pairs for antenna connection.
Fiber
optic cable doesn't pick up noise and has lower loss than cable.
Good gear!
http://www.foxcom.com/
It does look good, but I don't know yet if it will cover the AM band.
Something that covers .5-2MHz at a minimum would be required. I'll
investigate that further. Many of these seem to shift off to military use
when I research them.
Craig Healy
Providence, RI
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the
original contributors and do not necessarily reflect the opinion of the
IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx