Re: [IRCA] MFJ - 1026 Phaser observations...

["Craig Healy" <bubba@xxxxxxxxxxxxxxxxxxxx>]

> Does anyone have any tips as to ALA100 loop placements?
> Should the 2 loops please placed close to each other? at right angles?
> Would I be better off with different antennas?

I made two of the copper tube loops to phase.  I ended up with the same
results, even when the loops were 200 feet apart.  I attributed it to leaky
coax spoiling the source signal.  There may be something else at work,
though.  The same phaser attached to a 900' and a 450' wire works fine.  I'd
try a couple of wires.  The MFJ isn't the best, but it should provide some
useful phasing.

Craig Healy
Providence, RI

_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://arizona.hard-core-dx.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx