[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] I guess my new loop is working
- Subject: Re: [IRCA] I guess my new loop is working
- From: Russ Edmunds <wb2bjh@xxxxxxxxx>
- Date: Sat, 7 Jan 2006 12:03:55 -0800 (PST)
- Domainkey-signature: a=rsa-sha1; q=dns; c=nofws; s=s1024; d=yahoo.com; h=Message-ID:Received:Date:From:Subject:To:In-Reply-To:MIME-Version:Content-Type:Content-Transfer-Encoding; b=b8/jjPpGsGhaQqs6f+5SE9Pwav4R8rutJvE8aw7+wC2WPk00ZSSfU3qaf0hdG8GAQZ/pNuXyFneZbINknd/7I+1AbHaJOVK8ItcvF7QUeJLRkzoxqoSCKDuoYJNGlif/xd4uT8u68wTldyoV97CxOD/WdKf7dXsgG8p/NZcXLrc= ;
--- John Cereghin <pastor@xxxxxxxxxxxxxx> wrote:
> Ack! Questions!!! :)
>
> 1. 15 turns.
> 2. Indirect coupling. Using the ferrite rods in my portables. I
> have yet to try a direct hook-up to my FRG7 or my DX150B. That's
> next.
> 3. I have a ceremaic capacitor (salvaged from a crystal radio set)
> and a 1-gang and a 2-gang air capacitors. I'm experimenting with
> all three right now but currently have the ceremaic capacitor hooked
> up.
>
>
Sounds to me as if you ought to wire in the ceramic across the
terminals you're connecting to on the variable ( whichever of those
works better ). Normally, a failure to tune the low end of the band
inidicates a need for more capacitance; inability to tune the top
usually means not enough turns.
You'll need one variable with or without the ceramic as needed, to be
able to tune the loop.
I asked about how you were coupling to try to see if there might be an
issue there, but since you're using proximity coupling n o problems there.
Russ Edmunds
Blue Bell, PA ( 360' ASL )
[15 mi NNW of Philadelphia]
40:08:45N; 75:16:04W, Grid FN20ID
<wb2bjh@xxxxxxxxx>
FM: Yamaha T-80 & APS9B @15'
AM: Hammarlund HQ-150 & 4' FET air core loop
__________________________________________
Yahoo! DSL ? Something to write home about.
Just $16.99/mo. or less.
dsl.yahoo.com
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://arizona.hard-core-dx.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx