Re: [IRCA] Recording DX

[Russ Edmunds <wb2bjh@xxxxxxxxx>]

--- Martin and Wendy Foltz <martinfoltz@xxxxxxx> wrote:

>> 
> I have an old microphone that I will use for the line and connector.
> It's a
> stereo style, will this work for the line input?

*** It would, but I wouldn't. I'd use regular audio cable. I think
you'd get better results that way.

> 
> Do I need to do a resistor/capacitor network or just run direct? Hook
> it up
> to the 500 ohm output?
> 


*** You're going to be taking a receiver output of either 3.2 or 8
ohms, and going to a line input with an impedance of 50k or more. 

I use a simple audio output transformer which has inputs of 3.2 and 8 (
use whichever applies ) and outputs of 500, 1000, 2000 or more ohms -
if you can do 5k or 10k so much better. But 2k will work just fine.



Russ Edmunds
Blue Bell, PA  ( 360' ASL )
[15 mi NNW of Philadelphia]
40:08:45N; 75:16:04W, Grid FN20ID
<wb2bjh@xxxxxxxxx>
FM: Yamaha T-80 & Onkyo T-450RDS w/ APS9B @15'
AM: Hammarlund HQ-150 & 4' FET air core loop

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://arizona.hard-core-dx.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx