[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] DX Update From Northern DE (sort of) - reply
- Subject: Re: [IRCA] DX Update From Northern DE (sort of) - reply
- From: Peter Jernakoff <Peter.Jernakoff@xxxxxxxxxxxxxx>
- Date: Mon, 9 Jan 2006 21:13:28 -0500
- Sensitivity:
Bert -
>>On another note, tell me all about the other stuff pictured in your
photograph. what all do you have there? What's feeding what and so on...
My primary rx is a Drake R8B, the one that Anna is sitting on. I use a
Palstar R30CC as my secondary rx. I interface these to an IBM Thinkpad
using the line audio out of both rx. I plug right into the mic input of the
sound card and record using Total Recorder. I have two Quantum Phasers, one
of which is extensively used. The other is a backup in case the first wears
out. (I do use the Phaser heavily!!)
My antennas are as follows:
Antenna #1:
MFJ-1024 vertical 54" whip
which has been elevated to ~19'
using two Radio Shack antenna
mounting poles. Occasionally
used as a stand alone antenna.
Mostly used as a phase antenna
in conjunction with the below
indicated long wires.
Antenna #2:
~150' long wire (12 gauge
insulated copper wire from Home
Depot) sloping down (~18' peak
height) towards the NNE at an
~24 degree bearing (true).
Attached to an ICE Model 182A
matching transformer.
Antenna #3:
~160' long wire (12 gauge
insulated copper wire from Home
Depot) sloping down (~18' peak
height) towards the E at an ~94
degree bearing (true). Attached
to an ICE Model 182A matching
transformer.
Antenna #4:
Radio Plus+ Quantum QX Pro
Loop. Occasionally used as a
stand alone antenna or as a
phase antenna in conjunction
with the above indicated long
wires. Also destined to be used
on mobile DXpeditions (like to
the beach!).
Once the weather gets a bit
warmer and the swamp behind my
property dries out, I hope to
lay a few BOGs, ideally a pair
suitably separated but oriented
in the same direction and of
different lengths so that I can
phase them. I also have
everything I need to put up a
15' x 45' x 15' EWE which I
hope to do after I complete my
ham studies this spring.
If you'd like any additional
information, please contact me
off-line.
73,
-Pete Jernakoff-
K3KMS
Wilmington, DE
This communication is for use by the intended recipient and contains
information that may be Privileged, confidential or copyrighted under
applicable law. If you are not the intended recipient, you are hereby
formally notified that any use, copying or distribution of this e-mail,
in whole or in part, is strictly prohibited. Please notify the sender by
return e-mail and delete this e-mail from your system. Unless explicitly
and conspicuously designated as "E-Contract Intended", this e-mail does
not constitute a contract offer, a contract amendment, or an acceptance
of a contract offer. This e-mail does not constitute a consent to the
use of sender's contact information for direct marketing purposes or for
transfers of data to third parties.
Francais Deutsch Italiano Espanol Portugues Japanese Chinese Korean
http://www.DuPont.com/corp/email_disclaimer.html
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://arizona.hard-core-dx.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx