[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] Misek/Lankford/Ratzlaff proto test.
- Subject: Re: [IRCA] Misek/Lankford/Ratzlaff proto test.
- From: Chuck Hutton <charlesh3@xxxxxxx>
- Date: Tue, 26 Jun 2018 21:25:43 +0000
- Accept-language: en-US
- Authentication-results: spf=none (sender IP is ) smtp.mailfrom=charlesh3@xxxxxxx;
- Content-language: en-US
- Delivered-to: archive@xxxxxxxxxxxxxxxxxxxx
- Delivered-to: irca@xxxxxxxxxxxxxxxx
- Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=msn.com; s=selector1; h=From:Date:Subject:Message-ID:Content-Type:MIME-Version:X-MS-Exchange-SenderADCheck; bh=ngHji2VKD9s5iotGYu2i4OLCOseww+ASFhIpG4TgKiA=; b=cBR5WZr4c5isIozFIhzuwJ1xNmxozk6N3KvYboi+HQ5OE+WbEEX/V7O89GMBhVZApysBujtjDkokUuS+vMLY2ft/MqwsglpqpwN427qFcubGtGS6tk04ZXd+V80WejypKdpIehWmIpuJFoLECjNnoceYbBnDbrNciSumInzfIHfokjH3a+IbOtVsZmOCSt+fYvjZZb41e612J6yk04JUZDI2KekidOOs176ykFUQT4vvWRQM66bfDW0WPQBFhxe0jJS80bPeWznXAUgilgVuzqSVEiX0MA+oH9NDdcB2K+rWxbwLYYO7ossHgZdQ3E355A2EUL3FR3nLYqifM+Dbug==
- Thread-index: AQHUB2wFkFCPgN8LIUmVHmRz8PjPfaRm+AM2gARneYCAAAB6AIABFVaAgAAF+ICAAB/ygIAAEa2AgASrHgCAACXsAIAAFauAgAEG3ACAADiRgIAARRLR
- Thread-topic: [IRCA] Misek/Lankford/Ratzlaff proto test.
Id like to point out that it is quite feasible to phase a vertical;against a loop. It has been done for over 40 years. One variant of the idea was the LSCA, and reporints are / were available from the clubs about it.
But I didn't understand what is meant by the "hot end". Nor why phasing would affect what a DKAZ delivers.
Chuck
________________________________
From: IRCA <irca-bounces@xxxxxxxxxxxxxxxx> on behalf of Mark Durenberger <Mark4@xxxxxxxxxxxxxxx>
Sent: Tuesday, June 26, 2018 10:12 AM
To: 'Mailing list for the International Radio Club of America'
Subject: Re: [IRCA] Misek/Lankford/Ratzlaff proto test.
Mark, if you use an omni antenna to phase the D-Kaz you'll also be pulling
down signals from the "hot" end of the D-Kaz.
You might do better by phasing with a loop orthogonal to the D-Kaz; this
would help you wipe out stuff from the sides.
Cheers!
Mark Durenberger
-----Original Message-----
From: IRCA [mailto:irca-bounces@xxxxxxxxxxxxxxxx] On Behalf Of Mark Pettifor
Sent: Tuesday, June 26, 2018 8:51 AM
To: Mailing list for the International Radio Club of America
Subject: Re: [IRCA] Misek/Lankford/Ratzlaff proto test.
I'm open to suggestions on that. Currently I have a DKaz pointed south,
and a small vertical wire going from ground level up to about 30 feet
high in a tree. That is my "check" antenna because it's
omni-directional. (It also is closer to the house and any noise sources
within....)
On 2018-06-25 6:09 pm, Brandon Jordan wrote:
> Hi Mark. Perhaps, what antennae will you be using?
>
>> On Jun 25, 2018, at 3:52 PM, Mark Pettifor <mark@xxxxxxxxxxxxxx>
>> wrote:
>>
>> So if I've never used a phaser before, would this be a good "starter"
>> unit?
>>
>> Mark Pettifor
>> Goshen, IN
>>
>>
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the
original contributors and do not necessarily reflect the opinion of the
IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx