[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [IRCA] Misek/Lankford/Ratzlaff proto test.

Mark, if you use an omni antenna to phase the D-Kaz you'll also be pulling
down signals from the "hot" end of the D-Kaz.

You might do better by phasing with a loop orthogonal to the D-Kaz; this
would help you wipe out stuff from the sides.


Cheers!

Mark Durenberger


-----Original Message-----
From: IRCA [mailto:irca-bounces@xxxxxxxxxxxxxxxx] On Behalf Of Mark Pettifor
Sent: Tuesday, June 26, 2018 8:51 AM
To: Mailing list for the International Radio Club of America
Subject: Re: [IRCA] Misek/Lankford/Ratzlaff proto test.

I'm open to suggestions on that. Currently I have a DKaz pointed south, 
and a small vertical wire going from ground level up to about 30 feet 
high in a tree. That is my "check" antenna because it's 
omni-directional. (It also is closer to the house and any noise sources 
within....)

On 2018-06-25 6:09 pm, Brandon Jordan wrote:
> Hi Mark. Perhaps, what antennae will you be using?
> 
>> On Jun 25, 2018, at 3:52 PM, Mark Pettifor <mark@xxxxxxxxxxxxxx> 
>> wrote:
>> 
>> So if I've never used a phaser before, would this be a good "starter" 
>> unit?
>> 
>> Mark Pettifor
>> Goshen, IN
>> 
>> 
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the
original contributors and do not necessarily reflect the opinion of the
IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx

_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx