[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] PL-606 odd behavior in Lakeside, CA recently
- Subject: Re: [IRCA] PL-606 odd behavior in Lakeside, CA recently
- From: "Mark Durenberger" <Mark4@xxxxxxxxxxxxxxx>
- Date: Wed, 7 Dec 2011 09:21:35 -0600
Stephen, my two cents worth on a couple of things I noticed from your first
video:
++ If your goal was KSL:
1. You probably could have favored KSL against KCBQ by dialing to 1158 or
so...still within the KSL bandwidth but farther away from the 1170
sidebands. I'm sure you've done that.
2. You can probably do better on KSL by getting the radio off the ground
and orienting it toward Salt Lake...or away from KCBQ.
++ If your goal was to observe comparative signal strengths...I wouldn't
bother. I never rely on signal readings on any radio, but instead just go
for what's coming out of the speaker. As you've noted, signal strengths can
be so arbitrary and, depending on the radio, can actually be misleading.
Finally...that close to a 50-kilowatt signal, some radios simply go into
overload and all bets are off. That didn't sound like the case with your
PL-606 but it is a problem with some radios.
Please forgive, if I'm just re-stating the obvious <g>
Regards,
Mark Durenberger
--------------------------------------------------
From: "Stephen Airy" <pianoplayer88key@xxxxxxxxx>
Sent: Tuesday, December 06, 2011 11:31 PM
To: <irca@xxxxxxxxxxxxxxxx>
Subject: [IRCA] PL-606 odd behavior in Lakeside, CA recently
Hi all,
I was in Lakeside, CA, yesterday, and recorded a video clip of what
happens when I try to receive 1160-KSL at around local sunset using my
PL-606. I did mention a few things in the video's description...
http://www.youtube.com/watch?v=7eQql8niXLE
Is there some internal modification I could try so that I have the same
quality of reception as from 0:53 to about 1:00 or so as at other times
(while realizing the variability of skywave)? It'd be a bonus if
reception would also be like that a couple miles to the northwest or so.
;)
Also a month ago I recorded these two videos.
http://www.youtube.com/watch?v=fEMLcEqCu3E
http://www.youtube.com/watch?v=kEIU3mP5f38
Anyone have any idea what's going on, specifically, especially when I put
my radio & SAT up to the utility pole? ("Overload" isn't descriptive
enough - is it front-end, detector, audio rectifying signal bypassing
RF/IF stages, etc - what (technically?) is happening?)
Thanks for any education that can be sent my way. :)
73,
Stephen
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the
original contributors and do not necessarily reflect the opinion of the
IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx