Re: [IRCA] BOG question
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [IRCA] BOG question



Forgive me as I am not familiar with either one of those rx's. However, you can just try and see what works better in the field, or wrap a few turns of the BOG around the rx to inductively couple into its internal loopstick.

73 KAZ 

-----Original Message-----
>From: "HASCALL, DAVID CIV DFAS" <DAVID.HASCALL@xxxxxxxx>
>Sent: Dec 4, 2009 12:15 PM
>To: amdx@xxxxxxxxxxxxxxxx, irca@xxxxxxxxxxxxxxxx
>Subject: [IRCA] BOG question
>
>Let me ask this again:
>
>I've been toying with the idea of getting 5-600' of wire and hooking it
>to either my old DX-400 or newer S-350 and heading to the soccer fields,
>near work.  I do understand that both radios have built in antennas and
>that it would interject some signals too but at least I could orient the
>radio to compliment the BOG.  I used the DX-400 with a Sanserino loop in
>much the same way.  Both radios have two terminals, which one would I
>put the end of the BOG into (not using coax)?  An old Hallicrafters that
>I had as a kid had a similar A1 / A2 setup and a little metal "blade"
>that would short out A2, if desired.  Would plugging the BOG wire
>directly into one would work and would I need to do a small jumper from
>that one to the other one (A2)?  Thanks.
>
>73,
>Dave in Indy
>
>_______________________________________________
>IRCA mailing list
>IRCA@xxxxxxxxxxxxxxxx
>http://montreal.kotalampi.com/mailman/listinfo/irca
>
>Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
>
>For more information: http://www.ircaonline.org
>
>To Post a message: irca@xxxxxxxxxxxxxxxx
>

_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx