Re: [IRCA] Vast selectivity improvement for my SRF-M37V

["Mike Westfall, Lost Almost NM" <mwdx@xxxxxxxxxx>]

Gil,

I think that's probably too big to fit.

On Jan 2, 2008 4:53 PM, Gil Stacy <gilstacy@xxxxxxxxx> wrote:
> Bert,
> The cost of my filter was $5 more than the cost of an SRF59.  <vbg>
> Mike,
> My filter is a five pin filter, three pins ground and input and out put
> pins.  I'd probably lay it on its side as this will give a height of .25".
> The length is .375" and about .375" wide.  Any room inside the boards for
> this one?
> Gil
>
> _______________________________________________
> IRCA mailing list
> IRCA@xxxxxxxxxxxxxxxx
> http://montreal.kotalampi.com/mailman/listinfo/irca
>
> Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
>
> For more information: http://www.ircaonline.org
>
> To Post a message: irca@xxxxxxxxxxxxxxxx
>
>



-- 
Mesa Mike
LA de NM
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx