[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] longwire antennas
- Subject: Re: [IRCA] longwire antennas
- From: Charles A Taylor <MWDXer@xxxxxxx>
- Date: Sun, 06 May 2007 18:58:59 -0400
At 10:25 PM 5/6/2007 +0000, you wrote:
>William-
>
>There should ne no scarifice in performance as long as you keep the wire
>as straight as possible. I suggest you add as much lenghth as you
>possibly can. But, I do have a question about your steep hillside.
> Does your wire run up the hillside or down? Ideally, your wire should
> run DOWN the slope and not up. Also, what is your location? Good luck.
>
>--
>Marc DeLorenzo
>South Dennis, MA
=====================================================================================================
William,
Go ahead and string the antenna tree-to-tree. I wrote a piece about
doing the same thing back in about 1991. ENCEBE. In the IRCA
reprints.
As long as the wire maintains a fairly straight route, it loses no
directivity. But it must be terminated, and I would recommend driving
a four-foot ground rod and using a resistor of about 560 ohms.
Fair Radio Sales Co. sells WD-1A/TT "field phone wire" at $45 for
500 feet.
This is two-conductor stuff. It tends to have some splices. I
split off the wires and splice them end-to-end.
What makes WD-1A/TT wire so attractive is its durability. It
consists of three strands of steel wire and four strands of copper
wire, insulated by a very durable hard plastic. Solder-splicing it
is very easy with a 100-watt gun. Tape the splices so they don't
contact tree branches.
73, Charles
Charles A Taylor, WD4INP
Greenville, North Carolina
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx