[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [IRCA] DXing the West from a HOA Neighborhood



Kay,

Yes, thatâs the Wetlands area that I mentioned. There is ditch/stream that runs through that areaâand itâs much more grown up than when this photo was taken, but yes, itâs possible to run a bog through there. Probably 750-800 feet. 

Assuming that I terminate it at the far end, would that help with the Western loggings? I assumed it would be too directional to the North to be of much use. 

Iâd be happy to be wrong! 

73,


Les Rayburn, director
High Noon Media Services
130 1st Avenue West
Alabaster, AL 35007-8536
205-621-7500
205-621-7505 FAX
205-253-4867 CELL
highnoonfilm.com

[This message and any attached documents contain information from the sender that may be confidential and/or privileged. If you are not the intended recipient please notify the sender immediately by reply e-mail and then delete this message. Thank you.]




> On May 8, 2017, at 1:58 PM, Neil Kazaross <neilkaz58@xxxxxxxxx> wrote:
> 
> Looking at your place....*http://tinyurl.com/kb3vsek
> <http://tinyurl.com/kb3vsek>*
> 
> *Can you get a BOG toward the NW/NNW around that rock formation for what
> looks to be 600 or 700 ft at about 325 deg?  73 KAZ*
> 
> 
> On Mon, May 8, 2017 at 1:13 PM, Les Rayburn <les@xxxxxxxxxxxxxxxx> wrote:
> 
>> 
>> My primary interest in AM DXing is the reception of domestic stations from
>> the Western states. Unfortunately, I live on a small lot in a
>> deed-restricted neighborhood. Our HOA does not allow for the installation
>> of outdoor antennas, but Iâve managed to âhideâ a few behind our eight foot
>> tall privacy fence.
>> 
>> Our house sits at the end of the street, with a wetlands area directly
>> next to our lot. It is federally protected, and cannot be developed. This
>> expanse runs for about 1,200 feet and is about 200 feet wide.
>> Unfortunately, it runs almost due N/S.
>> 
>> Iâve thought hiding a BOG antenna in that area, which would help with
>> domestic loggings from those directions, but do nothing to feed my primary
>> interest.
>> 
>> Iâm well equipped to try a number of options, including two Wellbook ALA
>> 1530âs, a Wellbrook Flag antenna (not currently installed), and a Clifton
>> Labs Active Whip (not currently installed).
>> 
>> EMI noise is a major factor, but careful antenna siting minimizes it.
>> 
>> Any suggestions about the best configuration of the gear to maximize my
>> reception to the West?
>> 
>> 
>> 73,
>> 
>> Les Rayburn, N1LF
>> 121 Mayfair Park
>> Maylene, AL
>> EM63nf
>> 
>> Member WTFDA, IRCA, NRC. Former CPC Chairman for NRC & IRCA.
>> 
>> Elad FDM-S2 SDR, AirSpy SDR2, Quantum Phaser, Wellbrook ALA1530 Loop,
>> Wellbrook Flag, Clifton Labs Active Whip.
>> 
>> 
>> _______________________________________________
>> IRCA mailing list
>> IRCA@xxxxxxxxxxxxxxxx
>> http://montreal.kotalampi.com/mailman/listinfo/irca
>> 
>> Opinions expressed in messages on this mailing list are those of the
>> original contributors and do not necessarily reflect the opinion of the
>> IRCA, its editors, publishing staff, or officers
>> 
>> For more information: http://www.ircaonline.org
>> 
>> To Post a message: irca@xxxxxxxxxxxxxxxx
>> 
>> 
> _______________________________________________
> IRCA mailing list
> IRCA@xxxxxxxxxxxxxxxx
> http://montreal.kotalampi.com/mailman/listinfo/irca
> 
> Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
> 
> For more information: http://www.ircaonline.org
> 
> To Post a message: irca@xxxxxxxxxxxxxxxx
> 

_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx