Re: [IRCA] Miscou Island Prelim DX Report - Long

["Neil Kazaross" <neilkaz@xxxxxxxxxxxxx>]

Yes I misstyped..Seaside to Auckland is SW ie 225 degrees.. 73 KAZ
----- Original Message ----- 
From: "Chuck Hutton" <charlesh3@xxxxxxx>
To: "'Mailing list for the International Radio Club of America'" 
<irca@xxxxxxxxxxxxxxxx>
Sent: Sunday, September 25, 2005 10:23 PM
Subject: Re: [IRCA] Miscou Island Prelim DX Report - Long


> Sez what program? Auckland is about 222 degrees from Grayland according to
> Geoclock, making it SW.
>
> The 298 for Manila is right on so it would be WNW, Patrick.
>
>
> Chuck
>
> -----Original Message-----
> From: irca-bounces@xxxxxxxxxxxxxxxx [mailto:irca-bounces@xxxxxxxxxxxxxxxx]
> On Behalf Of Neil Kazaross
> Sent: Sunday, September 25, 2005 8:03 PM
> To: Mailing list for the International Radio Club of America
> Subject: Re: [IRCA] Miscou Island Prelim DX Report - Long
>
> Forgive me for being picky, but the direction from Seaside to Auckland is 
> SE
>
> of you, while the direction to Manila is about 298 degrees or actually a 
> tad
>
> north of WNW !! However, the EWE has a wide cardiod pattern and I just
> modeled your EW in EZNEC and assuming an arrival angle of 10 degrees the 3
> db beamwidth is 140 degrees, so signal arriving from 73 away from beampeak
> will only be down about 3.2 dB according to my modelling. So it is your
> proximity to the sea that is also helping you get Philippine DX.
>
> I've made all kinds of modelling changes to EWE's and there's nothing 
> funny
> happening at least as far as EZNEC can model it.
>
> 73 KAZ
> ----- Original Message ----- 
> From: "Patrick Martin" <mwdxer@xxxxxxxxx>
> To: "Mailing list for the International Radio Club ofAmerica"
> <irca@xxxxxxxxxxxxxxxx>
> Sent: Sunday, September 25, 2005 9:43 PM
> Subject: Re: [IRCA] Miscou Island Prelim DX Report - Long
>
>
>> Bert,
>>
>> A little more than that. The antenna has to be terminated to work
>> properly. I use a 2.5K ohm pot set at about 900 ohms.  I have several
>> ground rods at the termination point. The antenna should be fed with
>> coax and a matching transformer. I wrap my own. It is less money and
>> they work well. You want to isolate the antenna from the lead in. You do
>> not want the lead in to affect the directivity. My 22X100X22 EWE runs to
>> the NE and is directional to the SW. Aimed at the Philippines.
>>
>> 73,
>>
>> Patrick
>>
>> Patrick Martin
>> Seaside  OR
>> KAVT Reception Manager
>>

_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://dallas.hard-core-dx.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx