If IRRS Milano hadn't been stupid
with the truth of TX locations for 27 years,
publicly declaring rent bargains across Eastern Europe countries,
there would be no such research need.
wb
----- Original Message -----
From: "Mauno_Ritola" <Mauno.Ritola@gmail.com>
Sent: Wednesday, April 15, 2020 1:06 PM
Subject: Re: [WOR] IRRS 7290 kHz is NOT via Romania; RRI A-20 schedule
Hi Alexander,
thanks, you are right, I just got confirmation from Radiocom, that 7290
kHz 1700-1900 is not from them. But I don't think it is possible to get
a reply from Bulgarian operators.
73, MaunoAlexander Busneag kirjoitti 15.4.2020 klo 12:49:
Hi Mauno,
No, only two of the three Țigănești transmitters are currently
operational (TIG-tx2 and TIG-tx3).For some years, only TIG-tx1 and TIG-tx2 (both used by RRI) were
operational, while TIG-tx3 (reserve) was not ready for operation. This
explains why in the past years, most RRI transmissions via TIG-tx1
were cancelled when TIG-tx1 had technical problems, since TIG-tx3 was
not ready for use. However, a few RRI broadcasts were transmitted via
Săftica (SAF) in such cases.In the context of these technical problems with TIG-tx1, it is
nevertheless important to point out that the continuity of RRI's
broadcasts was not affected, since all Galbeni (GAL) and Țigănești
(TIG) transmissions go out on two parallel frequencies. This means
that listeners were always able to tune in to the second frequency
(via TIG-tx2)!A few weeks ago, the situation changed: TIG-tx1 is defective again,
but TIG-tx3 is finally operational again, and it temporarily carries
all frequencies scheduled for TIG-tx1. Hence, RRI is broadcasted on
all scheduled frequencies!There is no free space for the IRRS evening transmissions on 7290 kHz
at 1700-1900 UTC, since all available RADIOCOM SW transmitters are
used by RRI:1700-1800 UTC:
GAL-tx1: RRI Ron = 9500 kHz
GAL-tx2: RRI Ron = 11975 kHz
TIG-tx1: currently out of order!
TIG-tx2: RRI Eng = 11850 kHz
TIG-tx3 (replacing TIG-tx1): RRI Eng DRM = 9760 kHz
SAF: RRI Ukr (30 min) & Srp (30 min) = 5910 kHz1800-1900 UTC:
GAL-tx1: RRI Ron = 9500 kHz
GAL-tx2: RRI Ron = 11975 kHz
TIG-tx1: currently out of order!
TIG-tx2: RRI Deu DRM = 6090 kHz
TIG-tx3 (replacing TIG-tx1): RRI Deu = 9570 kHz
SAF: RRI Ita DRM (30 min) & Rup (30 min) = 5910 kHzFor further details, see:
http://ab27.bplaced.net/rri.pdf
As stated above, all frequencies scheduled for TIG-tx1 [T1] are
temporarily transmitted via TIG-tx3 [T3]!
73, Alexander_
Hard-Core-DX mailing list
Hard-Core-DX@hard-core-dx.com
http://montreal.kotalampi.com/mailman/listinfo/hard-core-dx
http://www.hard-core-dx.com/
http://www.hard-core-dx.com/article.php?story=20200415121502738