WBCQ Testing with 500 kW Audio on 9330 kHz

Saturday, May 11 2019

To identify the new WBCQ Continental 500kW unit on your ancient Sony,
just WBCQ used with low decreased of 135 kW power,
...
you may identify also with older Sony gear of 1985-1994year:
Set your Sony to 'Narrow/SYNC'  option
set manual Tune-Mode 'slow' of 100 Hertz channel separate,
and check your set's exactness - of 100 Hertz option,
when switch of/to nearby WINB 9265, 9330, and WRMI 9395 kHz
look to the SYNC red lights,
when light jumps from upper to lower side or vv ...
new Continental 500kW unit is exact even  x.000 kHz
older WBCQ txs #1 to #5 are odd mostly on air different
of 85 to 210 Hertz on upper side.
73 wolfie  df5sx
ps. used ICF2001 / 2010 sets since 1985
til now in 2019year - now on my bedroom ...

----- Original Message ----- 
From: "nri3 via Groups.Io" <nri3=yahoo.com.au@groups.io>

Sent: Saturday, May 11, 2019 3:13 PM
Subject: Re: [WOR] WBCQ Testing with 500 kW Audio on 9330 kHz
Weirdly, I've been picking up WBCQ on 9330 KHz during my evenings here,
usually after 1000 hrs UTC when I checked, for the last week or so. Signal
was an S8 consistently. So it's been more audible in Northwest New South
Wales at my QTH, than it ever has been in the past. In the past, best signal
was an S1 or 2 occasionally but JBA a lot of times.
Using an inverted V antenna with cable mounted on top of a metal shed roof
around 8 metres up or so. Program heard has been a very young Bro Stair.
Receiver used : Sony ICF 2001 D or an ICF 2010 same receiver.
regards
Tim Gaynor 


_
Hard-Core-DX mailing list
Hard-Core-DX@hard-core-dx.com
http://montreal.kotalampi.com/mailman/listinfo/hard-core-dx
http://www.hard-core-dx.com/


    


    
0 comments

    


    


        http://www.hard-core-dx.com/article.php?story=20190511154813995