Re: [IRCA] An easier way to switch out 9-volt batteries??

[Russ Edmunds <wb2bjh@xxxxxxxxx>]

Or replacement clamps with short pieces of wire attached shuold be available to use.

Russ Edmunds
15 mi NNW of Philadelphia  
Grid FN20id
<wb2bjh@xxxxxxxxx>
FM: Yamaha T-80 & Onkyo T-450RDS w/ APS9B @15'; Grundig G8
AM:  Modified Sony ICF 2010's barefoot


--- On Sun, 3/3/13, Rick Dau <drummer1965usa@xxxxxxxxx> wrote:

> From: Rick Dau <drummer1965usa@xxxxxxxxx>
> Subject: Re: [IRCA] An easier way to switch out 9-volt batteries??
> To: "irca@xxxxxxxxxxxxxxxx" <irca@xxxxxxxxxxxxxxxx>
> Date: Sunday, March 3, 2013, 7:52 PM
> 
> 
> At first, I was puzzled as to what you meant by "plastic
> frame", but now looking at an online photo of the back of
> the Quantum Loop V2.0, I see what you mean.  The frame is
> identical to the one on the Quantum QX loop that I used to
> own.  However, the QX Pro that I currently own is not a
> standard QX Pro -- whoever had it before me replaced the 9
> volt holder (with built-in unbreakable leads) with a battery
> clamp and floating-wire leads.  And now that those wires
> have broken a second time, I'm going to have it shipped back
> to Florida so Gerry Thomas can stick the original standard
> plastic frame back onto it (which I will wait to do until
> t-storm season is in full swing and I have less of an urge
> to DX MWand LW).  To hold me over until then, I'm going to
> have someone here in town solder both of those wires back
> onto the clamp, and after that, I will figure out a way to
> make sure the battery terminals touch the clamp (enough to
> activate the loop) without
>  having to snap the terminals on completely. 
>  
> 73,
> Rick Dau
> South Omaha, Nebraska
> 
> 
> ________________________________
>  From: Dave Hewitt <daveh200@xxxxxxxxxxx>
> To: Rick Dau <drummer1965usa@xxxxxxxxx>;
> Mailing list for the International Radio Club of America
> <irca@xxxxxxxxxxxxxxxx>
> 
> Sent: Sunday, March 3, 2013 4:00 PM
> Subject: Re: [IRCA] An easier way to switch out 9-volt
> batteries??
>  
> 
> I don't let my 9V battery snap into the connector on the
> QX.  I just snap it into the plastic frame and it is held
> tightly against the battery terminals.  Works fine.  There
> is minimal current flow.  
> 
> First time I used it, I snapped the battery fully into the
> connector.  Nearly broke it trying to get it out.
> 
> Dave N3BXY
> 
> ________________________________
> From: "Rick Dau" <drummer1965usa@xxxxxxxxx>
> To: ABDX@xxxxxxxxxxxxxxx,
> am@xxxxxxxxxxx, irca@xxxxxxxxxxxxxxxx
> Sent: Sunday, March 3, 2013 3:53:27 PM
> Subject: [IRCA] An easier way to switch out 9-volt
> batteries??
> 
>  
> Well, I've gone and done it again.  For the second time in
> recent months, while changing the 9-volt battery that powers
> my Quantum QX
>  Pro loop antenna, I've managed to break the clasp (the one
> that snaps onto the top of a 9-volt battery) apart from the
> negative wire that goes into the back of the base.  And
> this time, I managed to break off the positive wire, as
> well.  What I've been doing when switching out 9-volts is
> to take my index finger and thumb and pull the clasp off the
> battery.  Should I be using a flathead screwdriver, or
> something else, to pry it off?  Somehow, I'm using too much
> force, but I can't think of any other way. 
>   
> 73,
> a frustrated Rick Dau
> South Omaha, Nebraska
> _______________________________________________
> IRCA mailing list
> IRCA@xxxxxxxxxxxxxxxx
> http://montreal.kotalampi.com/mailman/listinfo/irca
> 
> Opinions expressed in messages on this mailing list are
> those of the original contributors and do not necessarily
> reflect the opinion of the IRCA, its editors, publishing
> staff, or
>  officers
> 
> For more information: http://www.ircaonline.org
> 
> To Post a message: irca@xxxxxxxxxxxxxxxx
> _______________________________________________
> IRCA mailing list
> IRCA@xxxxxxxxxxxxxxxx
> http://montreal.kotalampi.com/mailman/listinfo/irca
> 
> Opinions expressed in messages on this mailing list are
> those of the original contributors and do not necessarily
> reflect the opinion of the IRCA, its editors, publishing
> staff, or officers
> 
> For more information: http://www.ircaonline.org
> 
> To Post a message: irca@xxxxxxxxxxxxxxxx
> 
> 

_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx