Mark,
Was wondering about the high noise level. Would you have an opinion on
it's origin?
Alex
________________________________
From: Mark D Mobile <Mark4@xxxxxxxxxxxxxxx>
To: MDXC@xxxxxxxxxxxxxxx; Putrich Greg <gregp@xxxxxxxxx>; DX-IRCA
<irca@xxxxxxxxxxxxxxxx>; "DX @NRC" <am@xxxxxxxxxxx>
Sent: Wednesday, May 9, 2012 5:23 PM
Subject: [IRCA] Beverage Antenna in Utah Part Two
REPORT 2: We concluded our work on Monday 5/7 and 'struck the set'.
SDR recordings had been made over several evenings on both the elevated
Beverage and the BOG (1800 feet). Mike's suggested antenna azimuth was
validated by the high number of stations received in the corridor:
Eastern Washington--Western Montana. I'll post the catch-list later as
we look for the unlikely Alaska catches. I say unlikely BECAUSE:
In addition to the weather issues we encountered an abnormally high noise
level throughout the weekend. With the bandwidth we used (6 khz), the
SDRs were displaying noise around -75 to -80 dbm. (I'm used to Beverage
noise floors below -110.) This was one difficulty we just couldn't
overcome. The noise (certainly QRN) was broadband and continuous, as
opposed to the spiky stuff you hear when it's primarily atmospherics.
Other measurements involved switching an SDR between the elevated Bev and
the BOG and recording signal levels; both broadband and narrowband.
These results and other data will be published later. To be determined
on further playback is whether the BOG was performing as an
electrically-longer antenna than the elevated...on this very dry desert
floor.
On one occasion when we lit up in daytime we heard a rhythmic
interference spike several db above that dreaded broadband noise. Of
interest is that this noise was greatly reduced when we switched from the
elevated to the BOG.
The single-wire remote beverage terminator worked very well, as noted
earlier.
Further Facts Follow From us Fools in the Field.
Mark Durenberger
On the road
From: Mark D Mobile
Sent: Sunday, May 06, 2012 11:22 AM
.REPORT 1:
My friend Mike and I set up two 1800-foot Beverages in the Eastern Utah
desert...one is a BOG and the other elevated about 3 feet. Beverages are
at
320 degrees; we're looking for Alaska. Counterpoises on the ends are
four
300-foot radials of copper supplemented by ground rods.
The new single-wire remote termination control has proved a great
success.
Even though the DC resistance on our dry-desert-earth path measures close
to
2 megohms (!) the 'current amplifier' works well and drives a Vactrol for
ideal termination. (Of course "ideal" is only for one frequency but the
SDR
does a nice job of showing the overall front-to-back changes.)
We already know that it's working...those of you who've been in this area
know how tough it can be to remove KOB 770 in favor of KTTH, and KOKC in
favor of KKXA, without phasing...using only the F-B termination.
Today's work will include measurements (with two SDRs) comparing the
elevated Beverage and the BOG, logging RF levels across the MW band in
various conditions of connectivity. Of particular interest is what we
learn
when the BOG (running directly under the elevated wire) is used as a
counterpoise. Audio reports will appear on DXAS.
The weather has been semi-adverse. Nice temps...but strong winds have
meant
DUST! Today however appears a bit more benign.
We hope to share today's results in the next report.
Mark Durenberger
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the
original contributors and do not necessarily reflect the opinion of the
IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the
original contributors and do not necessarily reflect the opinion of the
IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx