[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] 1134 kHz "Buzz Saw" Grinding Away
I noticed the buzz saw again too, but I'm not set up to get a bearing.
It might be worthwhile to check tomorrow morning to see if it's still
around. I'm wondering if it's coming from CKWX. If someone in Victoria
can get a bearing, then we might be closer to finding out the source.
So far, it's only being heard by people within 100 km of my house.
As for Croatia, it was trying it's darndest to make it past the noise
tonight, which was an improvement over last night. If it weren't for
the buzz saw I might've had armchair copy.
Bruce
D1028Gary@xxxxxxx wrote:
Hello All,
As mentioned by Walt, the RF pollution on 1134 is back tonight, covering up
a carrier from Croatia that is up and down (coming close to audio at
times, if the "Buzz Saw" takes a fade when Croatia gets strong). I was able to
get a true bearing of 140 degrees (or its reciprocal of 320 degrees) on the
"Buzz Saw" from Puyallup, WA, based on the null bearing on the modified
ICF-2010.
73, Gary DeBock
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx