Re: [IRCA] How to phase BOG's? (Jim Glover)
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [IRCA] How to phase BOG's? (Jim Glover)



There has to be some explanation for why there was so little difference between the car radio and the BOG. Part of that is the length, part is no termination and part is no matching transformer. But it seems as if there should be something else.

That thought is magnified by the increase in signal strengths by putting a hand on the receiver, although since I'm not at all familiar with the receiver in question, if it has an internal ferrite bar antenna, that could partially explain it.


Russ Edmunds
Blue Bell, PA ( 360' ASL )
[15 mi NNW of Philadelphia]
40:08:45N; 75:16:04W, Grid FN20id
<wb2bjh@xxxxxxxxx>
FM: Yamaha T-80 & Onkyo T-450RDS w/ APS9B @15'
AM: Modified Sony ICF 2010 barefoot


--- On Tue, 9/29/09, Jim Glover <psykey@xxxxxxxxxxxx> wrote:

> From: Jim Glover <psykey@xxxxxxxxxxxx>
> Subject: Re: [IRCA] How to phase BOG's? (Jim Glover)
> To: "Mailing list for the International Radio Club of America" <irca@xxxxxxxxxxxxxxxx>
> Date: Tuesday, September 29, 2009, 12:51 AM
> On Mon, Sep 28, 2009 at 06:30:57PM
> -0400, Gil Stacy wrote:
> > Jim, Dave:
> > Dave, I doubt if Jim's car antenna was coupling with
> the BOG.
> 
> I can rule it out.  I rolled the BOG up, and then
> checked many
> of the stations again on my car radio.  The BOG was
> now once
> again a spool of wire in the trunk of my car, and the
> sations
> were still rolling in.
> 
> Thanks, Gil, for the additional information about phasing
> these things.  I don't really need to spend another
> C-note or
> two on one of these phasers ... but oh my, it is tempting.
> _______________________________________________
> IRCA mailing list
> IRCA@xxxxxxxxxxxxxxxx
> http://montreal.kotalampi.com/mailman/listinfo/irca
> 
> Opinions expressed in messages on this mailing list are
> those of the original contributors and do not necessarily
> reflect the opinion of the IRCA, its editors, publishing
> staff, or officers
> 
> For more information: http://www.ircaonline.org
> 
> To Post a message: irca@xxxxxxxxxxxxxxxx
> 
> 


      

_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx