Re: [IRCA] Indoor vertical update
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [IRCA] Indoor vertical update




On Feb 11, 2009, at 10:12 PM, Craig Healy wrote:

Until now it had been a couple of rooms away fed by a 40' length of RG-58 50 ohm coax. There was a significant noise issue and a number of birdies that swamped a number of frequencies. And, some electrical buzz would run for 30
seconds on and a minute off.  Gave me 2/3rds DX time.

I've taken to using quad-shielded RG-6 (cable TV drop cable). The garden-variety RG-58 and RG-8 doesn't have enough braid coverage to give good shielding. You can find quality RG-58 cable like Belden 8259, but it's expensive. Quad-shielded RG-6 cable has even better shielding and is cheaply available from Home Depot. You really do need to invest in a Snap-N-Seal tool and compression coax connectors. The Home Depot connectors are useless.

I replaced the RG-58 with CAT5 ethernet cable of about the same 40' length.

CAT5 is pretty good stuff, and handy where you have a balanced feed.

Best regards,
-Steve

--
Steve Byan <stevebyan@xxxxxxx>
Littleton, MA 01460


_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx