Re: [IRCA] GE Super Radio II question

[Tom L Jones <ka1yhi@xxxxxxxx>]

WD-40 can be used but keep it away from the dial cord !!
The power switch is about all that goes on SR's. 
We used to use it even on old UHF tuner ground forks & 
it worked wonders. Never had detuning problems, 
it seems to evaporate quickly.
Dont use it on anything that arcs also. Once I used it on
a skip-stop switch on an old Zenith remote set & went to the
front of the & held the channel button. POOF
a big flash. The customer was in awe.
73
Tom Jones
Mason N.H.

On Thu, 29 Nov 2007 17:28:17 -0800 "Eric Floden" <eric.f99999@xxxxxxxxx>
writes:
> My on-off switch is quite dodgy now.  The radio will only stay on now 
> when I
> hold the rather large on-off switch hard down.  It is as though 
> there is
> corrosion or whatever in the switch.  My lady friend taped it in 
> place, so
> it is always on, but that renders the tuning impossible.
> 
> Is there some kind of spray (like an electronics version of WD-40) 
> that I
> can spritz into the switch to make it young again?
> 
> thanks
> _______________________________________________
> IRCA mailing list
> IRCA@xxxxxxxxxxxxxxxx
> http://montreal.kotalampi.com/mailman/listinfo/irca
> 
> Opinions expressed in messages on this mailing list are those of the 
> original contributors and do not necessarily reflect the opinion of 
> the IRCA, its editors, publishing staff, or officers
> 
> For more information: http://www.ircaonline.org
> 
> To Post a message: irca@xxxxxxxxxxxxxxxx
> 
> 

_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx