[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[IRCA] frequency measurement accuracy
- Subject: [IRCA] frequency measurement accuracy
- From: Nick Hall-Patch <nhp@xxxxxxxx>
- Date: Sat, 02 Sep 2006 15:54:16 +0000
At 06:03 02/09/2006, you wrote:
>There is an issue of calibrating. Because of that, I just use it to
>determine activity and measure the relative difference between the
>signals. I measured a spike earler this week at 738.004 right before
>Sunrise.
>
>I am using spec lab. Maybe I need to figure out a better way to
>calibrate it.
>
I'm using Spectran, Bill (and Chuck), but when one sets up a receiver
for a, say, 400 Hz het, what guarantee do we have for the accuracy of
the receiver local oscillator? If a station is right on channel,
then Spetran/Spectrum Lab should read 400.0 Hz on the het, but that
is unlikely to be the case with commercial receivers (Al Lehr uses an
inherently more accurate precision frequency measurement system,
that's why I deferred to him. See IRCA reprint T079 for a
description. See Lee Freshwater for a CD of all IRCA reprints!)
We can check IBOC stations, which are supposed to be spot on
frequency, and apply corrections based on that. For example, KSL
should be on 1160.0000kHz, but my R8 and Spectran say that when I
tune to 1160.4 kHz, that a 395.54 Hertz results, so the R8 must be
nearly 5 Hz in error on that channel....Unfortunately, with the R8
it's not just an offset; there's a slope correction also (there's
different offsets depending on the frequency you're tuned to), so I
need to check several known frequencies. And that needs to be done
right at the time of the measurement of the unknown channel to
hopefully eliminate drift problems. It's not straightforward, but a
spreadsheet I made up helps.
The results on off frequency stations have been within a few tenths
of a Hertz with Al's published frequencies on the MWoffsets group, so
I'm hopeful.
Comments please?
****************************************************************************
Nick Hall-Patch
Victoria, B.C.
Canada
****************************************************************************
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://arizona.hard-core-dx.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx