[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] Dual feed loop
- Subject: Re: [IRCA] Dual feed loop
- From: mwdxer@xxxxxxxxx (Patrick Martin)
- Date: Tue, 14 Feb 2006 09:27:32 -0800
Craig,
My idea was to put a series of ground rods in at each termination point,
where a pot would go at the bottom of each element and adjust them
individually. Set the end one for the null, then go and adjust each leg
after that for a sharper null. I wonder if anyone has tried that.
73,
Patrick
Patrick Martin
Come to Seaside Oregon for the 2006 IRCA Convention! It will be held at
the Comfort Inn on September 22-24,2006.
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://arizona.hard-core-dx.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx