Re: [IRCA] Terminating resistor
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [IRCA] Terminating resistor



Hi Dennis,

Yes, I have the 2.5 K ohm Pot in a little plastic pill bottle. I make a
hole in the end and run the shaft through the hole and put the nut on.
So the shaft is sticking out. I then add a knob.  The wires go out the
top of the bottle where the top screws on. The 2.5K pot is easier to
adjust than the 5K though. It isn't as touchy. Bill Block in AZ says,
his works better at 1050 ohms, so it may vary from locale to locale. I
have so much water in the ground, the ohms might be lower for that
reason. 

73,

Patrick

Patrick Martin
Seaside  OR
KAVT Reception Manager

_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://arizona.hard-core-dx.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx