Re: [IRCA] IRCA Loop update

["Craig Healy" <bubba@xxxxxxxxxxxxxxxxxxxx>]

> > Could the antenna be
> > made from 4 straight sections designed to be
> > attached at the corners, then made transportable
>
> *** Let's think copper elbows with an inner diameter suitable for the
> pipe to fit snugly into. This could be snapped together and taken apart
> without a lot of difficulty. Seems to me as long as the fits are snug
> enough to not break the conductivity you'd have a knock-down portable
> model which would fit in a fishing pole ( or pool ) carrier.

Slot the elbows and tighten them with hose clamps.

Or, use three solder to pipe thread adapters and one slotted and clamped
joint so it can be assembled.

Craig Healy
Providence, RI


_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://arizona.hard-core-dx.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: irca@xxxxxxxxxxxxxxxx